[Info-vax] InfoServer 150

[bernhard.wulfmiteinemf at gmail.com]

Installed / Updated an Infoserver 150 some time ago.

In my notes I found the following...
Console port is MMJ port 1 (the one, next to the reset switch)
Break Enable switch needs to be in the down position.

For the update / installation I booted CD 6 (of 14) out of the Dec 1999 Software Product Library.
Will have a look for that CD-Rom to get an impression whats so special with it.

The installation started with a simple 
>>> b dka200 (that is the CD-Rom)

-DKA200

InfoServer 150 V3.5
Copyright (c) 1990 - 1997 Digital Equipment Corporation
%ESS-I-CONFIGDEV, Device configuration complete.  3 devices found
%ESS-I-FORMDISK, Formatting internal InfoServer disk, please wait...
%ESS-I-COPIED, Copy operation completed successfully.
%ESS-I-CREATEDBOOT, Boot partition created successfully.
%ESS-I-UPDATE, Update request completed successfully.
%ESS-I-UPDATESYS, Please REBOOT the InfoServer to run the installed version.
%ESS-I-VERIFY, Verifying DK1:

I know, V3.5 is not the most recent version, did an update to V3.5A later on.

Hope that helps.

Bernhard