[Info-vax] wrong file format

Phillip Helbig undress to reply helbig at asclothestro.multivax.de
Thu Dec 31 12:36:53 EST 2020


In article <rsk1o2$nqo$5 at gioia.aioe.org>,
helbig at asclothestro.multivax.de (Phillip Helbig (undress to reply))
writes: 

> In article <rsi2lj$du4$6 at dont-email.me>, Simon Clubley
> <clubley at remove_me.eisner.decus.org-Earth.UFP> writes: 
> 
> > On 2020-12-28, Phillip Helbig (undress to reply) <helbig at asclothestro.multivax.de> wrote:
> > >
> > > In the end, I managed to transfer it again (don't ask!) and somehow, 
> > > magically, it was OK.
> > >
> > 
> > If you still have the original version around, what does TECO do
> > to it if you read it in and write it out again ?
> 
> In order to avoid confusion, I deleted the bad version.  However, it 
> didn't look like the files which I've just opened and closed in TECO in 
> order to fix them.

Same problem today, but with a much smaller file (30 instead of 200,000 
blocks).  I loaded it into TECO then exited, then deleted the extra 
blank lines with a TECO learn sequence.  Still some problem.  I then 
went to the post-TECO file and noticed that a few lines had been broken 
at the wrong place (they are supposed to be all the same length).  I 
fixed those by hand with EDT (not possible with 100 MB), then TPU again.
In the end there was still something not 110% correct, but I could still 
use the file so all is well now.  :-)




More information about the Info-vax mailing list