[Info-vax] new VMS setup

[Mark Berryman]

On 4/30/21 3:07 PM, pcoviello at gmail.com wrote:
> we received a new BL870c with cisco 9148s switches and an 8440 3par.  I've connected fibre cables as of right now between the switch and a current 2660 and the 3par, but no luck seeing the disks I have presented to the 2660.
> 
> i configured the switch with the following  is there a step after this?
> none of the lights on the switch turned green.
> 
> also on the blade I am unable to access the virtual connection window due to flash no longer supported on my windows box,
> 
> any thoughts
> 
> thanks
> Paul
> 
> 
> NHSANSW1(config)# show zone
> zone name facs vsan 1
>    pwwn 50:01:43:80:01:69:74:84  2660
>    fwwn 20:0c:8c:60:4f:ef:a1:c0     switch
>    pwwn 20:01:00:02:ac:01:a6:e1    3par
>    fwwn 20:05:8c:60:4f:ef:a1:c0     switch
>    pwwn 21:01:00:02:ac:01:a6:e1  3par
>    fwwn 20:06:8c:60:4f:ef:a1:c0      switch
>    pwwn 22:01:00:02:ac:01:a6:e1  3par
>    fwwn 20:07:8c:60:4f:ef:a1:c0       switch
>    pwwn 23:01:00:02:ac:01:a6:e1   3par
>    fwwn 20:08:8c:60:4f:ef:a1:c0       switch
> 

You shouldn't need the fwwn entries.

Did you create a zoneset containing the zone?
Did you set the zoneset active?
Have you put license acquire statements on the ports in use and turned 
them up?
It sounds like you have multiple switches.  Have you configured any 
ports as expansion ports to connect the switches together?

There are a lot of steps to configuring a SAN switch.  You've only shown 
a tiny piece here.

Mark Berryman