[Info-vax] DECNET node address is inconsistant

[GeorgeinVT]

If I do a "$ show net" command - the output shows my DECNET node
address is 1.170 if I go into NCP my exec node is 1.176.  Below is the
output from a $SHOW NET/FULL ...

Can someone suggest where I can look to align the two addresses?

Thanks

------------------------------------------
system>show net/full

The following network services are available at this time:

Product:  DECNET                Manufacturer:  Digital Equipment
Corporation
Node:  RUSTY                     Address(es):  1.170
Network Type:  DNA IV           Interface(s):  net 0


Node Volatile Characteristics as of 17-SEP-2009 09:05:01

Executor node = 1.176 (RUSTY)

Identification           = DECnet for OpenVMS AXP V7.3
Management version       = V4.0.0
Incoming timer           = 45
Outgoing timer           = 60
Incoming Proxy           = Enabled
Outgoing Proxy           = Enabled
NSP version              = V4.1.0
Maximum links            = 32
Delay factor             = 80