[Info-vax] Pre-Ball Hockey-Puck mouse parts

[Bill Gunshannon]

In article <00ADA2DA.2D46A1CE at sendspamhere.org>,
	VAXman-  @SendSpamHere.ORG writes:
> In article <l2fsu0$mg2$1 at speranza.aioe.org>, Richard Maher <maher_rjSPAMLESS at hotmail.com> writes:
>>My mouse fell off the desk again only this time one of the little 
>>(pre-ball) contact pads/grommets came off. When I tried to push it
>>back on it revealed how old and perished it was by breaking in two
>>:-(
>>
>>Anyone had experience of replacing these with something readily 
>>available? HP still stock parts :-)
> 
> I may have a few of these.  Give me a couple of days to look through the
> stores.
> 
> I'm still looking for the mouse that was squared off with 15 pin D-plug
> connector.  It's for a retro-computer exhibit of a MicroVAX-II with the
> VCB01 graphics card.
> 

Seriously???  I think I still have one of them at home.  I will look
tonite if I get a chance.

bill

-- 
Bill Gunshannon          |  de-moc-ra-cy (di mok' ra see) n.  Three wolves
billg999 at cs.scranton.edu |  and a sheep voting on what's for dinner.
University of Scranton   |
Scranton, Pennsylvania   |         #include <std.disclaimer.h>