[Info-vax] Pre-Ball Hockey-Puck mouse parts

[Bill Gunshannon]

In article <bb2tacFp36cU1 at mid.individual.net>,
	bill at server3.cs.scranton.edu (Bill Gunshannon) writes:
> In article <00ADA2DA.2D46A1CE at sendspamhere.org>,
> 	VAXman-  @SendSpamHere.ORG writes:
>> In article <l2fsu0$mg2$1 at speranza.aioe.org>, Richard Maher <maher_rjSPAMLESS at hotmail.com> writes:
>>>My mouse fell off the desk again only this time one of the little 
>>>(pre-ball) contact pads/grommets came off. When I tried to push it
>>>back on it revealed how old and perished it was by breaking in two
>>>:-(
>>>
>>>Anyone had experience of replacing these with something readily 
>>>available? HP still stock parts :-)
>> 
>> I may have a few of these.  Give me a couple of days to look through the
>> stores.
>> 
>> I'm still looking for the mouse that was squared off with 15 pin D-plug
>> connector.  It's for a retro-computer exhibit of a MicroVAX-II with the
>> VCB01 graphics card.
>> 
> 
> Seriously???  I think I still have one of them at home.  I will look
> tonite if I get a chance.

No luck on the mouse at the moment, but I know it is here somewhere.
I'll keep looking....


How about a Digital H3060? :-)

bill

-- 
Bill Gunshannon          |  de-moc-ra-cy (di mok' ra see) n.  Three wolves
billg999 at cs.scranton.edu |  and a sheep voting on what's for dinner.
University of Scranton   |
Scranton, Pennsylvania   |         #include <std.disclaimer.h>