[Info-vax] startup hangs during TCPIP

Phillip Helbig undress to reply helbig at asclothestro.multivax.de
Mon May 18 16:39:06 EDT 2015


In article <1b83d5d7-0e4e-4c2d-9ade-fb9f1e08f65f at googlegroups.com>, 
Hans Vlems <hvlems at freenet.de> writes:

> A couple of ideas:
> - expired pak for vaxcluster; this doesn't block a satellite to boot but is a nuisance for other products
> - local page/swap device full
> - modified ucx pak and forgot to /include nodes; same, for vms.

No.

> - ethernet cable problem(s)

Maybe, but I doubt it since the network looks OK otherwise.

> - lan switch going bad

Ditto.

> - a lan device got removed or moved and tcpip suddenly misses a device

No.

> - memory problems on the satellite

It has 768 MB.

> What happens if you don't start ucx in systartup_vms but wait till 
that completes, 

It doesn't complete; it's a sequential startup.

> Does LAT work?

Yes.

Today, it didn't happen.

As soon as I can get the graphics problem straightened out, I'll go to 
8.4 and TCPIP 5.7, so it's probably not worth pursuing unless it happens 
again after than.




More information about the Info-vax mailing list