[Info-vax] Setting primary path on SAN

[Jan-Erik Söderholm]

Den 2018-05-10 kl. 19:08, skrev richard.brock57 at gmail.com:
> Hi all,
> 
> Recently we migrated our storage from Hitachi VSP to Hitachi 1500.
> During the migration festivities, the Hitachi folks rezoned and
> presented the new SAN along with the old one.  After I 'switched' all
> storage devices from the old SAN to the new one, the old SAN was
> "de-zoned" leaving only the new one visible to VMS.  After the "de-zone"
> operation I ran an SYSMAN> IO AUTO and found that the old SAN paths are
> showing as "unavailable".  Is this alright?  I guess this will go away
> after the next cluster/system reboot?
> 
> Also, on the old SAN one of the two paths to each device showed as
> 'Primary'.  This is no longer the case with the new SAN.  Off the top of
> my hand I can't think of a command which would set one of the new paths
> as primary.  Anyone?
> 

Neither do I and I have never done that, what I recall.

On our disks (4 paths) one is "current", one is "primary" and
the other 2 path are blank in that field...


> Thanks much in advance.
> 
> 
> rx2800 i2 x 4 with 1 dual-port HBA card in each node.
>