[Info-vax] rx8640 ILO MP port faulty?

[pcoviello at gmail.com]

On Tuesday, June 6, 2023 at 8:30:41 PM UTC-4, Bob Gezelter wrote:
> On Tuesday, June 6, 2023 at 3:30:44 PM UTC-4, pcov... at gmail.com wrote: 
> > hi, I can ssh to the ILO with out an issue, but when I try to browse to it no luck, and when I try to use parstatus to connect again no luck. we had another 8640 that worked fine, when I ran parstatus. could it be a setting inside the ILO that isn't set up or a faulty module? 
> > 
> > thanks 
> > pc
> pc, 
> 
> If I recall correctly, there are separate settings that enable the various protocols. Check the HELP text or the manual. There is also the possibility that the LAN segment has a configured limitation. 
> 
> EFI help is fairly useful in identifying the command. 
> 
> Been in similar situations with client systems. Best procedure is to check each and every relevant setting. 
> 
> - Bob Gezelter, http://www.rlgsc.com

I took out any network limitations with a 4 port switch and a single machine still the same issue.

when I go into CM and issue HE I'm not seeing anything obvious for a setting.

thanks
pc