[Info-vax] rx8640 ILO MP port faulty?

[pcoviello at gmail.com]

On Wednesday, June 7, 2023 at 9:23:20 AM UTC-4, pcov... at gmail.com wrote:
> On Tuesday, June 6, 2023 at 8:30:41 PM UTC-4, Bob Gezelter wrote: 
> > On Tuesday, June 6, 2023 at 3:30:44 PM UTC-4, pcov... at gmail.com wrote: 
> > > hi, I can ssh to the ILO with out an issue, but when I try to browse to it no luck, and when I try to use parstatus to connect again no luck. we had another 8640 that worked fine, when I ran parstatus. could it be a setting inside the ILO that isn't set up or a faulty module? 
> > > 
> > > thanks 
> > > pc 
> > pc, 
> > 
> > If I recall correctly, there are separate settings that enable the various protocols. Check the HELP text or the manual. There is also the possibility that the LAN segment has a configured limitation. 
> > 
> > EFI help is fairly useful in identifying the command. 
> > 
> > Been in similar situations with client systems. Best procedure is to check each and every relevant setting. 
> > 
> > - Bob Gezelter, http://www.rlgsc.com
> I took out any network limitations with a 4 port switch and a single machine still the same issue. 
> 
> when I go into CM and issue HE I'm not seeing anything obvious for a setting. 
> 
> thanks 
> pc
here is the error

C:\Users\Administrator>parstatus -u Admin:PASSWORD -h 10.xxx.xx.xxx
Note: No action specified. Default behavior is display all.
Error: Unable to connect to the nPar Provider on 10.xxx.xx.xxx.
1. Verify that the HP nPar Provider (WMINParProvider on Windows) is installed and running on 10.xxx.xx.xxx.
2. Verify that you are logged-in to the correct account (or have provided the correct username & password) to access the provider on 10.xxx.xx.xxx.
3. Verify that you have copied the server's SSL certificate from 10.xxx.xx.xxx to the trusted certificate store on the local machine (see man/help/readme).
Cannot connect to 10.xxx.xx.xxx:5989. Connection failed.

C:\Users\Administrator>parstatus -g Admin:PASSWORD -h 10.xxx.xx.xxx
Note: No action specified. Default behavior is display all.
Note: The -g option may require up to 2 minutes to complete.  Please wait...
Error: Failed to connect to target partition or complex.