[Info-vax] rx8640 ILO MP port faulty?

[pcoviello at gmail.com]

On Wednesday, June 7, 2023 at 1:09:29 PM UTC-4, pcov... at gmail.com wrote:
> On Wednesday, June 7, 2023 at 9:23:20 AM UTC-4, pcov... at gmail.com wrote: 
> > On Tuesday, June 6, 2023 at 8:30:41 PM UTC-4, Bob Gezelter wrote: 
> > > On Tuesday, June 6, 2023 at 3:30:44 PM UTC-4, pcov... at gmail.com wrote: 
> > > > hi, I can ssh to the ILO with out an issue, but when I try to browse to it no luck, and when I try to use parstatus to connect again no luck. we had another 8640 that worked fine, when I ran parstatus. could it be a setting inside the ILO that isn't set up or a faulty module? 
> > > > 
> > > > thanks 
> > > > pc 
> > > pc, 
> > > 
> > > If I recall correctly, there are separate settings that enable the various protocols. Check the HELP text or the manual. There is also the possibility that the LAN segment has a configured limitation. 
> > > 
> > > EFI help is fairly useful in identifying the command. 
> > > 
> > > Been in similar situations with client systems. Best procedure is to check each and every relevant setting. 
> > > 
> > > - Bob Gezelter, http://www.rlgsc.com 
> > I took out any network limitations with a 4 port switch and a single machine still the same issue. 
> > 
> > when I go into CM and issue HE I'm not seeing anything obvious for a setting. 
> > 
> > thanks 
> > pc
> here is the error 
> 
> C:\Users\Administrator>parstatus -u Admin:PASSWORD -h 10.xxx.xx.xxx 
> Note: No action specified. Default behavior is display all. 
> Error: Unable to connect to the nPar Provider on 10.xxx.xx.xxx. 
> 1. Verify that the HP nPar Provider (WMINParProvider on Windows) is installed and running on 10.xxx.xx.xxx. 
> 2. Verify that you are logged-in to the correct account (or have provided the correct username & password) to access the provider on 10.xxx.xx.xxx. 
> 3. Verify that you have copied the server's SSL certificate from 10.xxx.xx.xxx to the trusted certificate store on the local machine (see man/help/readme). 
> Cannot connect to 10.xxx.xx.xxx:5989. Connection failed. 
> 
> C:\Users\Administrator>parstatus -g Admin:PASSWORD -h 10.xxx.xx.xxx 
> Note: No action specified. Default behavior is display all. 
> Note: The -g option may require up to 2 minutes to complete. Please wait... 
> Error: Failed to connect to target partition or complex.


as an update to this I did update the cert, still haven't figured out how to download it, if it's even possible!