[Info-vax] no master member found for this virtual unit (again)

[RLFitch]

> $ MC SYSGEN
> set alloclass 3        ! or any value that strikes your fancy
> write current
> exit
To be clear, these were instructions from the previous thread (circa
2000). When I did this I began with "USE CURRENT" in SYSGEN.

I have to admit that I had forgotten about MODPARAMS.DAT only being
active during AUTOGEN. It's been a while since I've gone thru that.

Now for the output from SYSGEN (likely to be munged with line wraps):

-------------------------------------------------------------
SYSGEN>
SYSGEN>
SYSGEN>  USE ACTIVE
SYSGEN>  SHOW ALLOCLASS
Parameter Name           Current    Default     Min.      Max.
Unit  Dynamic
--------------           -------    -------    -------   -------
----  -------
ALLOCLASS                       3          0         0        255 Pure-
numbe


SYSGEN>  SHOW SHADOW
Parameter Name           Current    Default     Min.      Max.
Unit  Dynamic
--------------           -------    -------    -------   -------
----  -------
SHADOWING                       2          0         0          2
Coded-valu
SHADOW_SYS_UNIT                 7          0         0       9999 Unit
SHADOW_ENABLE                   0          0         0         -1
Bit_Code
SHADOW_SITE     "                "    "    "    "    "     "ZZZZ"
Ascii
SHADOW_MAX_UNIT               500        500        10      10000
Shadow Set
SHADOW_SYS_DISK                 1          0         0         -1
Bit_Code   D
SHADOW_MAX_COPY                 4          4         0        200
Threads    D
SHADOW_SYS_TMO                120        120         1      65535
Seconds    D
SHADOW_SYS_WAIT               480        480         1      65535
Seconds    D
SHADOW_MBR_TMO                120        120         1      65535
Seconds    D
SYSGEN>
SYSGEN>
SYSGEN>  USE CURRENT
SYSGEN>  SHOW ALLOCLASS
Parameter Name           Current    Default     Min.      Max.
Unit  Dynamic
--------------           -------    -------    -------   -------
----  -------
ALLOCLASS                       3          0         0        255 Pure-
numbe

SYSGEN>  SHOW SHADOW
Parameter Name           Current    Default     Min.      Max.
Unit  Dynamic
--------------           -------    -------    -------   -------
----  -------
SHADOWING                       2          0         0          2
Coded-valu
SHADOW_SYS_UNIT                 7          0         0       9999 Unit
SHADOW_ENABLE                   0          0         0         -1
Bit_Code
SHADOW_SITE     "                "    "    "    "    "     "ZZZZ"
Ascii
SHADOW_MAX_UNIT               500        500        10      10000
Shadow Set
SHADOW_SYS_DISK                 1          0         0         -1
Bit_Code   D
SHADOW_MAX_COPY                 4          4         0        200
Threads    D
SHADOW_SYS_TMO                120        120         1      65535
Seconds    D
SHADOW_SYS_WAIT               480        480         1      65535
Seconds    D
SHADOW_MBR_TMO                120        120         1      65535
Seconds    D

SYSGEN>  EXIT
-------------------------------------------------------------

Fortunately they look the same. Probably because I've not made any
changes since the last reboot.

I see that SHADOW_ENABLE is "0", yet I have managed to setup a
different shadow set 2 years back.

Ransom Fitch