[Info-vax] AUTOGEN: DCL-W-USGOTO, target of GOTO not found (SETPARAMS)...

[Jan-Erik Soderholm]

Paul Sture wrote 2013-04-16 15:56:
> In article <kkjkk4$fc5$1 at news.albasani.net>,
>   Jan-Erik Soderholm <jan-erik.soderholm at telia.com> wrote:
>
>> Hi.
>>
>> While running the automatic AUTOGEN after a 8.2 -> 8.4
>> upgrade (DS20e 666), it all finished with :
>>
>> %AUTOGEN-I-REPORT, AUTOGEN has produced some informational messages
>>           which have been stored in the file SYS$SYSTEM:AGEN$PARAMS.REPORT.
>>           You may wish to review the information in that file.
>>
>> %AUTOGEN-I-END, GENFILES phase has successfully completed.
>> %DCL-W-USGOTO, target of GOTO not found - check spelling and
>>     presence of label
>>    \SETPARAMS\
>>     SYSTEM       job terminated at 16-APR-2013 16:18:11.60
>>
>>
>> Then it just hanged, had to ctrl-P to get to the console.
>>
>> Anyone seen this before?
>
> I had a similar problem when I tried to run AUTOGEN on 8.3 as part of
> getting the latest Hobbyist licenses installed.  The old ones had
> expired so there were various startup problems.  On top of that I was
> running in a different emulator from the last AUTOGEN.
>
> Too many variables to investigate properly.  I did a CTRL-Y out,
> rebooted into a minimum system, applied the licenses then did another
> AUTOGEN and that was fine.
>

OK. :-)

This is a customer system, but that should not make any
difference I guess... :-)

Currently booting from the clean 8.2 disk (moved over by
a image backup/restore to a "new" DS20e).

Anyway, I'd expect SETPARAMS to be a valid label in AUTOGEN.COM...

Jan-Erik.