[Info-vax] SOLVED : Re: Process quota problem after upgrade to 8.4-2L1

[abrsvc]

On Tuesday, 22 December 2020 at 14:48:14 UTC-5, Dave Froble wrote:
> On 12/22/2020 1:05 PM, Arne Vajhøj wrote: 
> > On 12/22/2020 9:33 AM, Phillip Helbig (undress to reply) wrote: 
> >> In article <rrsk17$10p8$1... at gioia.aioe.org>, Joukj 
> >> <jo... at hrem.nano.tudelft.nl> writes: 
> >>> Thanks Hoff, You pointed me to the Right solution: Doubling all the 
> >>> pql_m* parameters did not help. But setting PQL_MPGFLQUOTA to 18000000 
> >>> (may be too high but set the same as for "user" system) did the trick. 
> >>> So also Tad's suggestion was correct. It wer the pagefile-quota. 
> >> 
> >> I'll see if this helps my problem. I remember adjusting quotas, but not 
> >> system parameters. 
> > 
> > My understanding is that setting PQL_MPGFLQUOTA sets 
> > the minimum PGFLQUOTA so that even those usernames 
> > with lower values in SYSUAF get the PQL_MPGFLQUOTA 
> > value. 
> > 
> > Are there scenarios where PQL_MPGFLQUOTA is required because 
> > SYSUAF value is not used?? 
> > 
> > Arne 
> > 
> >
> This is from 30+ year old memory. Beware! 
> 
> There are times when no user account is yet available. At that time, 
> the PQL quotas are used. Should one not be adequate, the debugging gets 
> "interesting". 
> 
> At least that's my dim recollection of the issue.
> -- 
> David Froble Tel: 724-529-0450 
> Dave Froble Enterprises, Inc. E-Mail: da... at tsoft-inc.com 
> DFE Ultralights, Inc. 
> 170 Grimplin Road 
> Vanderbilt, PA 15486

PQL parameters are used when the particular values are not specified in the CREPRC call.